Splatt Engineering Group | Food and Beverage Engineers

Splatt Engineering can offer Bottling Machines for Water, Wine, Beer, Soft Drinks and most other liquids.
We also do Water filling from 300ml through to 18 Litres. Complete Bottling lines with new or used Glass, PET, HDPE or Cans.
SEG has a full range of Equipment to suit your needs.

Splatts offer the complete range of CIME rinsing, filling, and closing equipment.

They offer two range of products:-

GOLD - Includes isobaric fillers suitable to
bottle carbonated products.

SILVER - Includes gravity fillers suitable to
bottle still products i.e without CO2

Splatt's currently uses these machines for wine, beer, water, soft drinks, spirits, champagne and fruit juice.

Cime

Ave Industries

Gravity

Filling is carried out by the liquid being delivered from a known head level and flowing by gravity.
Once the pre-set filling level is achieved, the excess product is returned to the filling tank.
Machine types suitable for treating PET/PE/HDPE bottles, the filler can be equipped with a neck holding system.

Gravity Light Pressure

With this system a constant pressure, by means of sterile air or inert gas, is created inside the filling tank. The pressure can be adjusted from 0,1 to 0,5 Bar.

The filling of the bottle is therefore facilitated by the pressure created inside the tank, filling to a prescribed level.

Once the pre-set level is achieved, the product in excess is collected in a recovery tank and afterwards it can be sent again to the process system, before filling.

In case the machine has to treat PET/PE/HDPE bottles, the filler can be equipped with a neck holding system.

Vacuum

This filling system is equipped with a vacuum pump that creates a depression inside the container.

Filling is carried out after the depression phase.
Once the pre-set level is achieved, the product in excess is returned to a recovery tank where it can be sent on to the process system if required.

Counter-pressure

This system is suitable to fill still or carbonated liquids at low or ambient temperature.

The filling product tank handles pressures of 6 Bar and is tested at a pressure of 9 Bar, certified by PED (EEC approved).

Machine models are available to treat PET/PE/HDPE bottles, the filler can be equipped with a neck holding system.

Hot Filling FHP/Cold Filling FCP

Filling is carried out by gravity and the system is suitable to treat products from an ambient temperature up to 90°C.

The excess product, after the self-levelling filling, is sent back to the preparation and filtration plant.
The product flow to the filler is adjusted by a modulating valve in order to give a constant control of the product flow.

Machine model are available to treat PET/PE/HDPE bottles, the filler can be equipped with a neck holding system

Volumetric

This system is equipped with a set of dosing pistons that take the product from the filling tank, positioned in the centre of the filler; the liquid is then volumetrically measured and is positively displaced into the container.

This is a highly effective and accurate system that can be either operated by pneumatic or mechanical actions.